After a prop. replacement and skag repair my boat wont go over 8mph? - boat prop repair
I repaired the marina 3.0li / or support new ones, the center and has established a new heroine. now more speed in accelerationg. What happened?
Sunday, January 3, 2010
Boat Prop Repair After A Prop. Replacement And Skag Repair My Boat Wont Go Over 8mph?
Subscribe to:
Post Comments (Atom)
7 comments:
The clutch on the propeller sound, it slips, have it checked and replaced if necessary.
The clutch on the propeller sound, it slips, have it checked and replaced if necessary.
It appears that your boat cavitation. It is the tool that is the old and the soil replaced, bad, may be the result.
Enjoy the new marina and say this might have the wrong equipment, or is damaged.
Replacing the heroine has little to do with cavitation.
My concern, however, it seems that you ran on a submerged rock, log, sand, another boat? etc. It can be some damage to the drive shaft in the propeller unit ... When this happens, the cost of repair would be higher if you have a defective or removed from the tree.
It appears that your boat cavitation. It is the tool that is the old and the soil replaced, bad, may be the result.
Enjoy the new marina and say this might have the wrong equipment, or is damaged.
Replacing the heroine has little to do with cavitation.
My concern, however, it seems that you ran on a submerged rock, log, sand, another boat? etc. It can be some damage to the drive shaft in the propeller unit ... When this happens, the cost of repair would be higher if you have a defective or removed from the tree.
Let me recap. You hit something under water. The workshop will take a propeller bent and shaken advised. But now that the boat is not like before. I think there are hidden damage. When the engine is a major concern, mounted on the wheel, I think it is spun. This means that if the burden for him, he slips. Therefore, any speed. It is usually a health insurance benefits, but I would boot back into the shop and let them check it out.
It appears that the proposal was ill-equipped. Make sure that the same as above. It is possible that the wrong tone in the blades.
Sounds like a defective or improperly installed in the center of the helix.
Post a Comment